Skip to main content

Int One mkII


Improving on the Int One proved quite a challenge. Lifting the level of performance significantly within the physical restrictions of the chassis was not only difficult, but at times also seemed impossible.

And why is that?
The Int One mkII differentiates from the previous model by having the pre-amp stage completely redesigned; now being fully balanced which offers overall greater gain, it also offers a higher bandwidth support with almost triple the volume sensitivty settings allowing you listen at levels from -79dB to +13dB.

This greatly increases the range of what type of rooms the Int One mkII supports: anything from now larger rooms to even smaller and dampened rooms, as sound quality and noise levels has not been compromised at either lower or higher volume settings.

Specifications Alluxity Int One

Specifications Alluxity Int One


Analogue 3 RCA / 2 XLR


Analogue 1 RCA Pre Out


8/4/2 ohm RMS ≈ 200W/400W/800W


Width 43.5 cm / 17.1 in

Height 10.5 cm / 4.1 in

Depth 33.5 cm / 13.2 in

Weight 17.5 kg / 38.5 pounds


Power consumption <1W/<50W (Standby/ON no load)

Input/output impedance 10 KΩ / 75 mΩ

Input sensitivity 2/4 Vrms (RCA/XLR)

Frequency response +800kHz

THD + noise >0.01%

Signal to noise ratio >100dB

Volume -69dB to +6dB

Leave a Reply